Esse conteúdo foi útil?
Como poderíamos tornar este artigo mais útil?
In the CLI, enter lmacli command, where command is the name of a specific command.
To see a list the commands currently available to Lyve Mobile Array CLI, enter lmacli --help.
For help with a specific command, enter lmacli command --help. Example: lmacli discover --help
Command | Description |
---|---|
configure | Import configuration for the device from the Lyve Management Portal or set it up manually. |
discover | Discover Lyve Mobile devices in the neighborhood. |
disk-info | Display information about the disks. |
fde-decrypt | Disable Full-Disk Encryption. |
fde-init | Initialize Full-Disk Encryption. |
fde-repurpose | Crypto-erase data to repurpose the device. |
fde-unlock | Unlock the device. |
fw-info | Display information about the firmware. |
fw-update | Update the firmware. |
info | Display general info about the device. |
log-dump | Copy the device logs to a Zip archive. |
rackmount-setup | Set up a Lyve Mobile Array in a Lyve Mobile Rackmount Receiver. |
raid-cleanup | Remove all RAID arrays. |
raid-dequarantine | Remove RAID arrays from quarantine. |
raid-info | Display information about the RAID arrays. |
raid-setup | Create a single RAID array (uninitialized). |
usb-setup | Set up the management interface if connected over USB or Thunderbolt. |
version | Display the CLI version. |