Was this content helpful?
How could we make this article more helpful?
In the CLI, enter lmacli command, where command is the name of a specific command.
To see a list the commands currently available to Lyve Mobile Array CLI, enter lmacli --help.
For help with a specific command, enter lmacli command --help. Example: lmacli discover --help
| Command | Description |
|---|---|
| configure | Import configuration for the device from the Lyve Management Portal or set it up manually. |
| discover | Discover Lyve Mobile devices in the neighborhood. |
| disk-info | Display information about the disks. |
| fde-decrypt | Disable Full-Disk Encryption. |
| fde-init | Initialize Full-Disk Encryption. |
| fde-repurpose | Crypto-erase data to repurpose the device. |
| fde-unlock | Unlock the device. |
| fw-info | Display information about the firmware. |
| fw-update | Update the firmware. |
| info | Display general info about the device. |
| linux-usbnet-setup | Set up the management interface if connected over USB or Thunderbolt. |
| log-dump | Copy the device logs to a Zip archive. |
| rackmount-setup | Set up a Lyve Mobile Array in a Lyve Mobile Rackmount Receiver. |
| raid-cleanup | Remove all RAID arrays. |
| raid-dequarantine | Remove RAID arrays from quarantine. |
| raid-info | Display information about the RAID arrays. |
| raid-setup | Create a single RAID array (uninitialized). |
| version | Display the CLI version. |
| volume-map | Map the volume in USB, Thunderbolt, or NVMe mode. |